A wiper blade is worn out when its rubber edge has hardened, not only when it tears. The clear signs are long streaks on the glass, chatter and knocking as the blade moves, and arcs of glass left unwiped at the edges. In Iraq this happens faster because a parked car sits for hours in the sun and the rubber hardens above 50 °C. Dust and fine sand act like sandpaper on the edge. A blade run on a dry screen wears faster and can scratch the glass, so wet the screen first.
Measure the blade before buying a new one. The length is printed in the car handbook or on the old package and is given in inches; common sizes run from 16 to 26 inches. Check the arm type as well: most cars use a hook or J-hook arm that locks the blade with a small metal hook, and some models use a pin arm fixed from the side. Replace both blades together, because an old blade next to a new one leaves an uneven sweep. Lower the arm carefully so it does not hit the glass.
Blades last only a short time in a hot climate. On a car parked in the Baghdad sun a blade usually works six to twelve months, while in a mild climate it can last two years. Before fitting new blades, clean the screen with glass cleaner and a clay bar to lift stuck film and fine grit. Use a stronger screen-wash mix for Iraqi dust, since plain water spreads the dirt. Wipe the new blade with a soft cloth and check its edge every month.