The first number on an oil label, as in 10W-30, describes cold flow, and the second describes thickness at operating temperature. The hot number decides whether the oil film survives 45 to 52 °C days. A 20W-50 stays thicker in extreme heat and suits older, looser engines, but it costs fuel. A 5W-40 or 10W-30 flows faster and carries heat away better, which is usually the right choice for modern engines, including most Japanese and Korean models on Iraqi roads. Match the API category (SN, SP) and the ACEA sequence (A3/B4, C3) to the owner's manual.
High ambient heat matters because oil thins as it warms. Once the oil is too thin, pressure drops, the film between bearing and crankshaft breaks down, and wear rises. Heat also speeds oxidation, so oil darkens and thickens sooner, especially on short city trips in Baghdad. Dust makes it worse: fine sand passes the air filter and loads the oil with abrasive particles. In dusty Basra conditions or after desert trips, shorten the interval to 5000-7500 km.
Check the level on level ground with a cold engine, or ten minutes after switching off, and keep it between the dipstick marks. Full synthetic oil resists heat and oxidation better than mineral oil, and a blend is a reasonable middle option for older engines. Pair the oil with a quality filter, because a cheap filter bypasses dirt or collapses. Common mistakes are mixing grades, topping up without checking the level after a leak, and trusting the windscreen sticker instead of the dust and heat the car actually sees.